Quantifying how much raw material is needed: A case study based on the weight of the lithic artefacts from the Brno-Štýřice III Epigravettian site (Moravia,Czech Republic)

This paper compares the quantification of different raw materials in a chipped stone assemblage by weight and by number at the site of Brno-Štýřice III in Moravia, Czech Republic. The use of the same reduction technology for all raw materials means that the Brno-Štýřice III assemblage is a good case study. The result demonstrates that semi-local raw material tends to dominate numerically, but in terms of weight, there is a significant change in the predominant raw material. The paper contextualizes the results in relation to other assemblages and discusses the possible reasons for this phenomenon.     

Groundwater discharges in the Baltic Sea: survey and quantification using a schlieren technique application

Groundwater seeps are known to occur in Eckernförde Bay, Baltic Sea. Their discharge rate and dispersion were investigated with a new schlieren technique application, which is able to visualize heterogeneous water parcels with density anomalies down to Δσ_t = 0.049 on the scale of millimeters. With the use of an inverted funnel, discharged fluids can be captured and the outflow velocity can be determined. Overall, 46 stations could be categorized by three different cases: active vent sites, seep‐influenced sites, and non‐seep sites. New seep locations were discovered, even at shallow near‐shore sites, lacking prominent sediment depression, which indicate submarine springs. The detection of numerous seeps was possible and the groundwater‐influenced area was defined to be approximately 6.3 km². Flow rates of between 0.05 and 0.71 l m^?2 min^?1 were measured. A single focused fluid plume, which was not disturbed by the funnel was recorded and revealed a flux of 59.6 ± 20 ml cm^?2 min^?1 and it was calculated that this single focused plume would be strong enough to produce a flow rate through the funnel of 1.32 ± 0.44 l m^?2 min^?1. The effect of different seep‐meter funnel sizes is discussed.     

Non-dietary Marks in the Anterior Dentition of the Krapina Neanderthals

A sample of 82 anterior teeth from Krapina (Croatia) was studied using a light binocular microscope and a scanning electron microscope to document the presence of non-dietary dental scratches. The patterns of distribution, location and orientation of these marks suggest two different aetiologies: scratches on the labial-occlusal enamel border appear to be related to the action of clenching abrasive materials between teeth, while the scratches primarily in the centre of the labial face correspond to cutmarks as described by other researchers. These scratches may have been produced when flake tools involved in processing materials held between the anterior teeth came into contact with the labial enamel face. Alternatively, they may simply reflect some consistent operation which pulled hard objects across the labial surfaces of the anterior teeth. In either case, the marks on the central face of the labial surface provide evidence for manual dexterity in the Neanderthals. Of the seven Krapina individuals which show a predominant pattern, one shows a pattern of left oblique marks, while six provide evidence of right-handedness. Coupled with other Neanderthal or Upper Pleistocene individuals with these patterns, right-handedness is the dominant pattern in 90 per cent of the documented cases. One complicating factor in the analysis of these scratches in the Krapina hominids is that marks of a similar morphology are found in several anterior teeth of Ursus spelaeus from the site. While resembling the marks on the hominid incisors, the scratches on the bears lack a dominant orientation on the labial face and appear to be more variable in their widths. Despite the occurrence of some similarities in the enamel scratches between ursids and hominids at Krapina, the study of anterior dental marks provides information about manipulative activities which are unique to ancient humans. © 1997 by John Wiley & Sons, Ltd. Int. J. Osteoarchaeol., 7 : 133–149 (1997) No. of Figures: 9. No. of Tables: 5. No. of References: 34.     

Incisor labial surface wear striations in modern humans and their implications for handedness in Middle and Late Pleistocene hominids

Over the past four decades several workers have argued that the orientations of striations on the labial surfaces of the front teeth of Middle and Late Pleistocene fossils attributed to Neanderthals and antecedent archaic hominids can tell us something about handedness. These researchers have suggested that such scratches result from stone tools scraping across the incisors during ‘stuff‐and‐cut’ behaviours, and that they reflect directions of hand movements and handedness. In this study, we examine comparable wear features on the incisors of anatomically modern humans to determine whether striation angle may reflect handedness. The teeth from 66 individuals representing four groups with known differences in subsistence practices (Aleut, Arikara, Illinois Bluff, and Puye) were examined. Photomicrographs were made of the maxillary central incisor labial surfaces of all individuals at 56× magnification. These photomicrographs were scanned to image files, and orientations of all visible wear striations were measured using a semi‐automated image analysis procedure. Approximately three‐quarters of all labial surfaces showed a preferred striation orientation. Of those, most had preferred apico‐cervical or vertical striation orientations, independent of cultural affiliation. Few showed the tendency toward diagonally‐oriented scratches expected if handedness is related to scratch orientation. We found no evidence for ‘stuff‐and‐cut’ striations, despite the fact that at least one of the groups studied—the Aleut—are documented to have used this behaviour. In sum, there is evidently no relationship between striation orientation and handedness in the groups studied. It is, therefore, unlikely that labial scratch orientation in Middle and Late Pleistocene hominids reflects handedness if they used their front teeth in a manner comparable to that of any of the anatomically modern groups considered here. Copyright © 1999 John Wiley & Sons, Ltd.     

Tracing sickle blade levels of wear and discard patterns: a new sickle gloss quantification method

Although sickle blades gloss is known to form during the harvest, which is a dynamic process and although it is known to be a type of wear which is the outcome of the repetitive encounters between the sickle blades working edges and plant stems; there is no common way to quantify its intensity. Since there is no consensus over a specific scale that will enable the estimation of the amount of wear, based on the quantification of gloss brightness intensity. In this paper we propose a new measurement system which is based on the projection of laser (He–Ne) beam on glossed sickle blades and an analysis of the reflected images. The results form a relative scale from which it is possible to infer on the sickle blades level of wear, and to create discard models.     

The combined use of oxygen isotopes and microwear in sheep teeth to elucidate seasonal management of domestic herds: the case study of Çatalhöyük,central Anatolia

This paper presents and tests a model designed to investigate how off-site herd management developed in settled pre-historic societies. The model is constructed from data collected from traditionally raised local sheep, acting as an interpretive link to published data. The modern comparator was small, but plausible results allow modelling of the archaeological data to be explored. Birth seasonality and herding location are identified through modelled patterns in oxygen isotope data in tooth enamel, and diet just before death by microwear in the same tooth. In combination, these allow aspects of seasonal management of breeding, fallow and slaughter herd sections to be interpreted. Novel practices are discussed in comparison local wild sheep ethology. The case study is Neolithic Çatalhöyük (7400–6200 cal BC) in central Anatolia. Its location provided the opportunity for different parts of the landscape to be used for herding, although choice might have been socially constrained. Data are taken from 72 specimens; the results suggest settlement-wide preference for a suite of practices that kept herds within a day of the settlement and that maintained breeding cycle synchrony with optimal resource availability. Chronological analysis suggests birth season manipulation was tried but rejected, whilst hay or cereal fodder was introduced and became increasingly important. It is argued that herding was probably on dedicated pasture on the arable fringes rather than in closer integration on ‘garden plots’, as there is no evidence of field-edge weed diets and little evidence of adjusting the birth season to accommodate the crop cycle.     

Frontiers of Contact: Bioarchaeology of Spanish Florida

The arrival of Europeans in the New World had profound and long-lasting results for the native peoples. The record for the impact of this fundamental change in culture, society, and biology of Native Americans is well documented historically. This paper reviews the biological impact of the arrival of Europeans on native populations via the study of pre- and postcontact skeletal remains in Spanish Florida, the region today represented by coastal Georgia and northern Florida. The postcontact skeletal series, mostly drawn from Roman Catholic mission sites, are among the most comprehensive in the Americas, providing a compelling picture of adaptation and stress in this setting. Study of paleopathology, dental and skeletal indicators of physiological stress, stable isotope (carbon and nitrogen) analysis, tooth microwear, and skeletal morphology (cross-sectional geometry) reveals major alterations in quality of life and lifestyle. The bioarchaeological record indicates a general deterioration in health, declining dietary diversity and nutritional quality, and increasing workload in the contact period. The impact of contact in Spanish Florida appears to have been more dramatic in comparison with other regions, which likely reflects the different nature of contact relations in this setting versus other areas (e.g., New England, New France). The bioarchaeological record represents an important information source for understanding the dynamics of biocultural change resulting from colonization and conquest.     

Testing Area‐Scale Fractal Complexity (Asfc) and Laser Scanning Confocal Microscopy (LSCM) to Document and Discriminate Microwear on Experimental Quartzite Scrapers

Few microwear studies have been conducted on tools made from quartzite. Most rely on visual observation of microwear features using optical light microscopes and scanning electron microscopes. Quantification of microwear on quartzite tools is extremely rare, even though numerous methods to mathematically document surface roughness have been applied to other silicate tools. In this paper, laser scanning confocal microscopy (LSCM) was used to document surface roughness on four experimental scrapers made from two different subtypes of Mistassini quartzite that were used on either fresh or dry deer hide. Surface roughness data were analysed using area‐scale fractal complexity (Asfc). The results of this test case indicate that Asfc can effectively discriminate between the unused and used regions on the quartzite tools based on surface roughness, and that it can also discriminate between surface roughness produced by working dry versus fresh hides. Differences in the subtypes of Mistassini quartzite did affect surface roughness, but not significantly enough to prevent discrimination of the dry and fresh hide‐working tools. Although the use of the Asfc parameter for lithic microwear analysis requires further testing, these first results suggest it could be a reliable technique to mathematically document and discriminate wear patterns on archaeological quartzite tools.     

Dental Microwear and Diet in Domestic Sheep (Ovis aries) and Goats (Capra Hircus): Distinguishing Grazing and Fodder-fed Ovicaprids using a Quantitative Analytical Approach

In recent years, dental microwear analysis has attracted considerable interest as a potential method for reconstructing ancient diet. This article presents results from research exploring the potential of dental microwear analysis in the reconstruction of domestic ungulate diet through the quantitative analysis of diet-microwear relationships in modern grazing and fodder-fed sheep and goats. Diet-related microwear patterning is identified in the modern populations examined and it is concluded that with investigation of a wider range of modern diets, dental microwear analysis will emerge as a valuable and insightful approach for the investigation of diet in ancient livestock.     

Comparing bird bones from Saxon sites: problems of interpretation

Bird bones from Saxon settlements in England provide evidence for considerable exploitation of birds, especially domestic poultry. This paper discusses some of the problems of analysing the relative importance of birds and of the ratio of fowls and geese. Detailed comparison of the results from sites in Southampton suggest that the first questions the faunal analyst should be asking concern methods of recovery and quantification. © 1997 John Wiley & Sons, Ltd.