THE POSSIBLE FRACTIONATION OF LEAD ISOTOPES IN ANCIENT METALLURGICAL PROCESSES

The possibility of lead isotope fractionation in ancient lead production is examined. Kinetic theory relating to isotopic fractionation in non-equilibrium evaporation is considered and the feasibility of the alteration of lead isotope abundance ratios in ore roasting and smelting is assessed. Previous experimental work is shown to have been inconclusive and conclusions are drawn on the need for further research to quantify the possible extent of fractionation in practice.     

ARCHAEOMETRIC INVESTIGATIONS AT THE UNIVERSITY OF SOFIA,BULGARIA

The paper presents a brief overview and history of archaeometric research using instrumental neutron activation analysis at the Faculty of Chemistry of the University of Sofia. The archaeometric projects are listed and some of the results obtained in the investigations of glass, pottery and metals are described.     

THE PROVENANCE AND TECHNOLOGY OF NEAR EASTERN GLASS: OXYGEN ISOTOPES BY LASER FLUORINATION AS A COMPLEMENT TO STRONTIUM*

The ability to make rapid measurements on small samples using laser fluorination enhances the potential of oxygen isotopes in the investigation of early inorganic materials and technologies. δ¹⁸O and ⁸⁷Sr/⁸⁶Sr values are presented for glass from two primary production sites, four secondary production sites and a consumer site in the Near East, dating from Late Antiquity to the medieval period. δ¹⁸O is in general slightly less effective than ⁸⁷Sr/⁸⁶Sr in discriminating between sources, as the spread of measured values from a single source is somewhat broader relative to the available range. However, while ⁸⁷Sr/⁸⁶Sr is derived predominantly from either the lime‐bearing fraction of the glass‐making sand or the plant ash used as a source of alkali, δ¹⁸O derives mainly from the silica. Thus the two measurements can provide complementary information. A comparison of δ¹⁸O for late Roman – Islamic glasses made on the coast of Syria–Palestine with those of previously analysed glasses from Roman Europe suggests that the European glasses are relatively enriched in ¹⁸O. This appears to contradict the view that most Roman glass was made using Levantine sand and possible interpretations are discussed.     

LEAD ISOTOPE ANALYSIS OF ARCHAEOLOGICAL METALS BY MULTIPLE‐COLLECTOR INDUCTIVELY COUPLED PLASMA MASS SPECTROMETRY*

Lead isotope ratios in archaeological silver and copper were determined by MC–ICPMS using laser ablation and bulk dissolution without lead purification. Laser ablation results on high‐lead metals and bulk solution analyses on all samples agree within error of TIMS data, suggesting that problems from isobaric interferences and/or mass bias variations due to the presence of matrix elements are insignificant. Inaccurate laser ablation analyses on low‐lead copper reflect erroneous mass bias corrections from use of a non‐matrix matched standard. However, in most cases, silver and copper are analysable for lead isotopes by bulk dissolution or laser ablation MC–ICPMS with simplified sample preparation.     

A LEAD ISOTOPE DATABASE: THE LOS PEDROCHES – ALCUDIA AREA (SPAIN); IMPLICATIONS FOR ARCHAEOMETALLURGICAL CONNECTIONS ACROSS SOUTHWESTERN AND SOUTHEASTERN IBERIA*

One hundred and twenty‐five new lead isotopic analyses on galena, mainly from the Los Pedroches – Alcudia Valley area of southern Iberia, are presented. These data allow us to define four compositional groups in the ²⁰⁷Pb/²⁰⁶Pb versus ²⁰⁸Pb/²⁰⁶Pb and ²⁰⁷Pb/²⁰⁶Pb versus ²⁰⁶Pb/²⁰⁴Pb diagrams. Group I compositions are intermediate between those previously reported for southeastern and southwestern Iberian ore mineral locations. The compositions of Group II, the largest group, overlap with ore data from southwestern Spain. Groups III and IV have compositions that have never before been identified in this region and are comparable to those from the Sardinian Cu ores, which might explain the previously assumed exotic origin for local Bronze Age artefacts.     

INCISED SLIPWARE PRODUCTION AT CASTELFIORENTINO (FLORENCE): THE ‘VIA BERTINI’ SITE (15TH–17TH CENTURIES)*

This study deals with the physical–chemical and mineralogical–petrographic investigations (OM, SEM–EDS, EPMA, ICP, XRpD, Mössbauer and IR) conducted on first‐ and second‐firing wasters belonging to two types of incised slipware (sgraffito), manufactured at Castelfiorentino between the late 15th and the early 17th centuries. Raw materials, colouring agents and firing products were analysed in order to establish the production technology of the ceramic coatings, by means of detailed microtextural and chemical investigations. The pottery underwent two firing processes: the firing of the white slip‐coated ceramic body and a further firing after application of the glaze. The homogeneity of the raw materials, white slip and glaze is remarkable, and demonstrates the use of well‐established recipes with a constant supply of raw materials from the same places. Highly efficient kiln management during both firings is revealed by body–glaze interface reactions.     

EVALUATION OF BINDER/AGGREGATE RATIOS IN ARCHAEOLOGICAL LIME MORTARS WITH CARBONATE AGGREGATE: A COMPARATIVE ASSESSMENT OF CHEMICAL,MECHANICAL AND MICROSCOPIC APPROACHES*

This paper reports on the comparative evaluation of traditional and innovative methods for the investigation of mortar technology. Preliminary results of various approaches to determining the mix proportions in lime mortars with carbonate aggregate are presented. Quantitative analysis was tested on ad hoc prepared mortars of known composition containing carbonate aggregates of different origin (travertine and Bath limestone). Wet chemical methods, manual disaggregation and Digital Image Analysis of thin sections and cross‐sections stained with Alizarin Red S were tested. The advantages and drawbacks of the different approaches are discussed, and applications to the analysis of archaeological mortars and plasters are highlighted.     

HUMAN MOBILITY AT THE EARLY NEOLITHIC SETTLEMENT OF VAIHINGEN,GERMANY: EVIDENCE FROM STRONTIUM ISOTOPE ANALYSIS*

As evidence concerning human mobility during the transition to agriculture in central Europe, we present the results of strontium isotope analysis of human skeletons from the Neolithic village of Vaihingen, Germany. We find significantly more ‘non‐local’⁸⁷Sr/⁸⁶Sr values from humans buried in a Neolithic ditch surrounding Vaihingen than from those buried within the settlement. These results fit with previous studies showing a correlation between burial circumstances and strontium isotope signatures from LBK cemeteries of southwestern Germany ( Price et al. 2001 ; Bentley et al. 2002 ). A pilot study of Neolithic animal teeth from Vaihingen suggests that either ‘local’⁸⁷Sr/⁸⁶Sr signatures were more variable than the analysed human bones suggest, or that these domestic animals themselves were mobile, perhaps ranged by mobile pastoralists.     

LEAD ISOTOPE ANALYSES OF ISLAMIC POTTERY GLAZES FROM FUSTAT,EGYPT*

Lead isotope analyses have been undertaken on a group of Islamic lead‐glazed pottery artefacts from Fustat, Egypt, spanning the period from the eighth to the 14th century ad , that had previously been the subject of a comprehensive typological, chronological, petrographic and technological study. Comparison of the lead isotope ratios for the glazes with those for lead ores from Egypt, Iran, Tunisia, Anatolia, Greece, Sardinia and Spain provided information on the possible sources of the lead used in the production of the glazes. The results show that the lead used in glaze production by the Islamic potters at Fustat was most probably obtained from distant ore sources in Iran or Tunisia, Sardinia, Spain and the Taurus Mountains. Different ore sources were favoured in different periods and, to a limited extent, for different types of pottery, but at no time did the Fustat potters use the potentially more accessible Egyptian ore sources.     

LEAD ISOTOPE ANALYSIS OF TANG SANCAI POTTERY GLAZES FROM GONGYI KILN,HENAN PROVINCE AND HUANGBAO KILN,SHAANXI PROVINCE

Through the use of MC–ICP–MS, this study analyses the lead isotope ratios of 19 Tang Sancai pottery glazes unearthed from the Gongyi and Huangbao kiln sites. According to their different lead isotope ratios, the two kilns can be grouped separately. The research also suggests that the Gongyi and Huangbao kilns are independent production centres of Tang Sancai in the Tang Dynasty. The data from the Huangbao kiln indicates that the lead in the glazes originates from the Northern China geochemical province, while the data from Gongyi kiln suggests its source as the Yangtze geochemical province. Furthermore, the results obtained for the Tang Sancai pottery indicate that the lead sources for glaze making of these two kilns were very consistent, which suggests that lead isotope analysis could be a helpful method to identify the kilns producing Tang Sancai artefacts.