Stiffness Behavior and Shear Effect in Partially Infilled Reinforced Concrete Frames

The captive column effect is regarded as one of the deficiencies in concrete buildings. During earthquakes, partially infilled frames often get damaged due to large shear force within columns. Past studies indicate that the column failure is due to the high shear force occurrence; however, exact quantification of the shear force is still a topic of interest. A particular analytical expression for strut width has been adopted in this article and it is concluded that the masonry walls do enhance stiffness of frames but due to the shear force, the walls play adverse role in damaging the columns.     

Seismic Behavior Prediction of Flanged Unreinforced Masonry (FURM) Walls

In most available studies, unreinforced masonry (URM) walls are idealized as rectangular sections, while in reality walls have effective sectional shapes such as C, I, T, and L. In this article, the results of experimental and analytical assessment of flange effects on the behavior of I- and C-shaped URM walls are reported. Four clay brick walls at half scale were tested. Two specimens were designed with I- and C-shaped sections, and for comparison, two additional specimens were designed without flanges. The tests showed that under constant axial load the strength of the I-shaped wall increases, but that of the C-shaped wall decreases, because of out-of-plane distortion effects. Despite the loss of strength, both flanged walls indicated almost similar initial stiffness, deformation capacity, and mode of failure in comparison with walls without flanges. A mixed-mode analytical model is proposed to predict the lateral force displacement curve of flanged URM (FURM) walls. The proposed analytical model is based on section analysis of the walls and shows good agreement with previous experimental results.     

Seismic Response of a Four-Story Miniature Building with Replaceable Plastic Hinges

To emphasize on linear and nonlinear seismic behavior of building systems in education, a four-story miniature moment-resisting frame steel building was designed, built, and tested in a shaking table at the Structures Laboratory of the Department of Civil Engineering at the University of Canterbury, New Zealand. A prominent feature of the building is the incorporation of elements designed to form plastic hinges that can be easily replaced after a test with minimum effort and at a very low cost. This model is mainly aimed at education in undergraduate and graduate structural dynamics/earthquake engineering courses and it has also been used to support research. This article describes in detail the main features of the building, its design, and discusses the response of the building to two input ground motions. Because the use of pushover analyses is becoming an industry standard, the some relevant results will be compared with those predicted by such kind of analyses. This article is written in very simple terms and is aimed at the undergraduate and graduate student, at educators in structural design and at structural engineers involved in seismic design of building structures. This article covers many aspects that are seldom highlighted in building behavior to earthquake excitation and that are not always covered in design codes or guidelines.     

Source Effects on the Spectral Characteristics of Strong Ground Motions Recorded in Bucharest Area During Vrancea Earthquakes of 1986 and 1990

The August 30, 1986 (M_W ?=?7.1) and May 30, 1990 (M_W ?=?6.9) Vrancea intermediate-depth earthquakes, despite their almost similar magnitudes, have produced very different spectral contents as shown by the strong ground motions recorded in Bucharest and its surroundings. The differences can be attributed to different epicentral distances and to different values of the stress drop. The characteristics of the seismic ground motions recorded in Bucharest area in the 1986 and 1990 seismic events are discussed in the context of (a) the source characteristics of the two earthquakes and (b) the local soil conditions in Bucharest. Furthermore, an attempt is made to determine the soil factors S defined in EN 1998-1 EN 1998-1. 2004. Design of Structures for Earthquake Resistance – Part 1: General Rules, Seismic Actions and Rules for Buildings, CEN.  [Google Scholar] for the Bucharest area, based on the strong ground motion dataset recorded during the two seismic events.     

Characterization of Ductility and Inelastic Displacement Demand in Base-Isolated Structures Considering Cyclic Degradation

New designed or retrofitted structures with the use of isolation system may exhibit nonlinear deformations during strong ground motions. Inelastic displacement ratio of base-isolated structures is studied in this paper by employing two degree of freedom model taking into account inelastic behavior of isolators and superstructure. Parametric study is conducted to evaluate influence of isolator and superstructure properties on inelastic displacement ratio according to two sets of near-fault and far-fault ground motions. Accuracy of proposed equations in the literature to evaluate inelastic displacement ratio are studied, as well. Furthermore, cyclic degradation effects are investigated by considering stiffness and strength degradation and pinching in hysteresis model of superstructure. Eventually, inelastic responses of isolated structures with two types of isolators (lead rubber bearing and friction pendulum bearing) are compared.     

The Strength Reduction Factors for Seismic-Isolated Bridges Characterized by SDOF Bilinear Systems in Far-Fault Areas

This article presents a statistical study on strength reduction factors for seismic-isolated bridges in far-fault areas. 1410 ground motions are selected and modified to be compatible with the recommended response spectra. Then, they are divided into 60 groups to investigate the effects of PGA/PGV ratios, soil conditions and post-to-pre-yield stiffness ratio. Results show that reduction factors are significantly affected by the PGA/PGV ratio, while the latter two items are not as important as the first one. Finally, an improved equation to estimate the reduction factor is proposed, and the accuracy of the equation is verified by additional records.     

社会经济因素对区域经济发展的影响——兼论我国经济重心的地域移动

在剖析影响我国经济重心地域移动的主要因素中,本文着重分析探讨了社会经济因素对区域经济发展的影响,并提出了社会经济因素中六个亟待探讨的方面。     

Seismic Stability of Slope Considering Rayleigh Wave

In the present paper factor of safety of slope under seismic loading condition is evaluated assuming circular failure surface. Using Fellenius method the center of most critical circle is located. Adopting limit equilibrium method, under the influence of weight of potential sliding mass and seismic inertia forces, factor of safety is evaluated considering Rayleigh wave along with primary wave and shear wave. Results are presented and compared with the available results from literature. Detailed parametric studies are also carried out to observe the variation of safety factor at different soil strength and seismic forces.     

Corporate kin-groups,social memory,and “history houses”? A quantitative test of recent reconstructions of social organization and building function at Çatalhöyük during the PPNB

It has been argued that the corporate kin-group was the main form of socioeconomic organization at the Turkish site of Çatalhöyük during the Pre-Pottery Neolithic B (PPNB). This hypothesis is linked to a claim of long-term repetitive patterning in the use of household space. Çatalhöyük's corporate kin-groups, it is suggested, would have been maintained by social memory, and social memory would have been created by the repeated rebuilding of houses with the same floor plan and by the burial of important members of the corporate kin-groups under house floors. This hypothesis been taken up by a number of authors in recent years. However, it is not clear how much confidence should be invested in the hypothesis as the use of household space at Çatalhöyük during the PPNB has not been subject to formal evaluation. With this in mind, we carried out a study in which we examined the relationship between continuity in house floor plans and the percentage of houses that contain burials. To assess the co-variation between these variables, we developed a GIS-based method of quantifying house wall continuity, and then subjected the resulting index and a number of other variables, including the percentage of houses that contain burials, to factor analysis. The results of the analyses do not support the hypothesis. The house-wall continuity index and the percentage of houses that contains burials load on different factors, which indicates that they do not co-vary through time. This is contrary to the predictions of the corporate kin-group hypothesis. Thus, claims that during the PPNB Çatalhöyük's occupants formed corporate kin groups that were maintained by social memory and “history houses” should be curtailed and interpretations built on this hypothesis should be viewed with suspicion.     

Knowledge-Based Performance Assessment of Existing RC Buildings

One of the most challenging aspects of the seismic assessment of existing buildings is the characterization of structural modeling uncertainties. Recent codes, such as Eurocode 8, seem to synthesize the effect of structural modeling uncertainties in the so-called confidence factors that are applied to mean material property estimates. The confidence factors are classified and tabulated as a function of discrete knowledge levels acquired based on the results of specific in-situ tests and inspections. In this approach, the effect of the application of the confidence factors on structural assessment is not explicitly stated. This work presents probabilistic performance-based proposals for seismic assessments of RC buildings based on the knowledge levels. These proposals take advantage of the Bayesian framework for updating the probability distributions for structural modeling parameters based on the results of tests and inspections. As structural modeling parameters, both the mechanical material properties and also the structural detailing parameters are considered. These proposals can be categorized based both on the amount of structural analysis effort required and on the type of structural analysis performed. An efficient Bayesian method is presented which relies on simplified assumptions and employs a small sample of structural model realizations and ground motion records in order to provide an estimate of structural reliability. As an alternative proposal suitable for code implementation, the simplified approach implemented in the SAC-FEMA guidelines is adapted to existing structures by employing the efficient Bayesian method. This method takes into account the effect of both ground motion uncertainty and the structural modeling uncertainties on the global performance of the structure, in a closed-form analytical safety-checking format. These alternative proposals are demonstrated for the case study structure which is an existing RC frame. In particular, it is shown how the parameters for the safety-checking format can be estimated and tabulated as a function of knowledge level, outcome of tests, and the type of structural analysis adopted.